Maruyama BL3100 Manual do Operador

BL3100HAND-HELD BLOWER

Handheld Blower Safety1. Make sure the Handheld Blower is correctlyassembled as instructed in the Assembly sectionof this manual.2. Before each use, i

Operating Safety1. THIS HANDHELD BLOWER CAN CAUSESERIOUS INJURIES. Read the instructions care-fully. Be familiar with all controls and the properuse o

— 11 —Product DescriptionBL3100123456789101211131. Pipe B2. Pipe A3. Air Intake Screen4. Stop Switch5. Throttle Setting Lever6. Throttle Trigger7. Han

AssemblyBlower Pipes Installation1. Align groove in pipe A with pegs on blower hous-ing and slide pipe A on to housing.2. Rotate pipes A clock wise to

Before OperationOil and Fuel1. Do not smoke near fuel.2. Mix and pour fuel outdoors and where there areno sparks or flames.3. Always shut off the engi

Do not use automotive motor oil. This type ofoil does not have the proper additives for air-cooled, 2-cycle engines and can cause enginedamage.Recomm

Mixing InstructionsIMPORTANT: Never mix gasoline and oildirectly in the Handheld Blower fuel tank.1. Always mix fuel and oil in a clean containerappro

— 16 —2. Move the choke lever to the closed ( ) position 3. Move the stop switch to the “ON” position.4. (1) Press the throttle trigger.(2) Move the t

Hot RestartTo start the engine that is already warmed up (hotrestart), or if the ambient temperature exceeds 68°F(20°C):1. Pump the primer bulb at the

MaintenanceMaintenance, replacement or repair of emissioncontrol devices and systems may be performed byany repair establishment or individual; howeve

— 1 —Limited Warranty StatementAll Maruyama commercial/ industrial products are warranted to the original purchaser to be free from defectsin material

Air FilterMaintenance Interval• The air filter should be cleaned and inspectedeach time the Handheld Blower is used, or moreoften when working in extr

— 20 —Spark PlugMaintenance Interval• The spark plug should be removed from theengine and checked after each 25 hours of opera-tion.• Replace the spar

— 21 —4. Clean all dirt and debris from the cooling fins andfrom around the cylinder base.5. Reinstall the topcover and the cleaner cover.Engine Scree

3. Remove and clean the tail, gasket and sparkarrester with a safety solvent and a stiff brush. Ifany part cannot be thoroughly cleaned, it must bere

— 23 —Air Intake ScreenMaintenance IntervalThe air intake screen should be cleaned and inspectedeach time Handheld Blower is used and when air flowdro

6. Pull the starter grip once.7. Slowly pull the starter grip to bring the piston tothe top of the cylinder (TDC).8. Reinstall the spark plug.9. Store

Every Every EveryMaintenance Daily 20 hours 50 hours 100 hoursCheck and replenish fuel●Check for fuel leakage●Check bolts, nuts and screws for tightne

— 26 —Emission durability of 300 hours.※1. Dry weight without Pipe A and BModel BL3100Dimensions L x W x H 12.8 x 10.0 x 14.6in (325 x 255 x x370mm)Dr

Maruyama U.S., Inc.3570 Shelby LaneDenton, TX 76207 U.S.AP.O. Box 2107Denton, TX 76202 U.S.APhone 940-383-7400Fax 940-383-7466www.maruyama-us.com28255

— 2 —This warranty does not cover the following:1. Maintenance items (excluding defects in materials and workmanship) including hoses, spark plugs,sta

— 3 —FEDERAL AND CALIFORNIA EMISSION CONTROL WARRANTY STATEMENTYOUR WARRANTY RIGHTS AND OBLIGATIONSThe U.S. Environmental Protection Agency (EPA), the

— 4 —OWNER'S WARRANTY RESPONSIBILITIES:(a) As the small off-road engine owner, you are responsible for the performance of the requiredmaintenance

— 5 —The California Air Resources Board's Emission Warranty Parts List specifically defines the emis-sion-related warranted parts, (EPA's re

— 6 —PageLimited Warranty Statement ... 1California Emission Control ... 3Intr

— 7 —Thank you for purchasing a Maruyama product.Maruyama, it’s distributors, and dealers want you to becompletely satisfied with your new product. P

The Maruyama warning system in this manual identi-fies potential hazards and has special safety messagesthat help you and others avoid personal injury